HONDA 3D-Emblem (groß)
[Inhalt festlegen]
Emblem-Aufenthalt X1
Tülle X2
Größe]W185XH45mm
Werkstoff/Material] Edelstahl
Schaftdicke] 2,0 mm
Produktionsland]Japan
*Zum Zeitpunkt der Installation wird der Steg mit M10-Bolzen (2 Punkte) befestigt. In diesem Fall wird der Steg durch das Anzugsdrehmoment der Schrauben besiegt, wodurch sich der Steg verzieht. Dasselbe Problem tritt auch beim Lösen der Schrauben auf. Es wird daher empfohlen, Fett oder Rosette zu verwenden, um den Reibungswiderstand zwischen Bolzen und Stegen zu verringern.
*Drehen Sie den Lenker nach der Installation ganz nach links und rechts und achten Sie darauf, dass er nicht mit der Motorhaube kollidiert. Wenn sie die Motorhaube stört, lösen Sie die Schrauben wieder und stellen Sie den Lenker ein.
■HONDA 3D emblem (large)
[Set components]
・Emblem bracket x 1
・Grommet x 2
[Size] W185 x H45mm
[Material] Stainless steel
[Bracket plate thickness] 2.0mm
[Country of manufacture] Japan
*When installing, secure with M10 bolts (2 points).In this case, the strength of the bracket is outstripped by the tightening torque of the bolt, causing the bracket to sag.The same phenomenon also occurs when loosening.Therefore, we recommend using grease, rosettes, etc. to secure the bolt and bracket during installation to reduce frictional resistance between the bolt and bracket.
*After installation, turn the handlebar all the way to the left and right to confirm that there is no interference with the cowl or other components.If there is interference with the cowl, loosen the bolts again and make adjustments.