Eingebaute Blinker
Klare/gerauchte Linsen
Plug-and-Play
Integrierte LED-Rückleuchten
Lastausgleichswiderstand
Bedienungsanleitung
*Wenn eine Gebrauchsanweisung beigefügt ist, wird diese in Englisch sein.
Für den Einsatz außerhalb der USA: Wenn Sie ein Blinkrelais kaufen, stellen Sie sicher, dass Ihr Anzeigesystem ein 2-Pin-Relais und kein 4-Pin-Relais verwendet, und beachten Sie die Pin-Konfiguration. Beachten Sie auch die Pin-Konfiguration. Beachten Sie, dass das 4-Pin-Relais nicht installiert werden kann. Geeignet für Lochabstände von 5,4-6,1 Zoll zu Zoll mit 5 mm-Hardware. Bitte prüfen Sie vor dem Kauf die Kompatibilität.
Dieser Artikel wurde vom US-Verkehrsministerium nicht genehmigt und entspricht möglicherweise nicht den in Ihrem Land geltenden Gesetzen und Vorschriften.
・Built-in Turn Signal
・Clear / smoke lens
・Plug & Play
・LED Integrated Taillight
・Load balance resistor
・Instruction Manual
*The instruction manual, if included, will be in English.
For use outside the United States: If you buy a flasher relay, make sure your blinker system uses a 2-pin relay and not a 4-pin relay.Also, pay attention to the pin configuration.Please note that 4-pin relays cannot be installed.If you have purchased a Fender Eliminator, please note that TST Industries brackets are designed for US plates.5mm hardware accommodates hole spacing of 5.4 to 6.1 inches to inch hole spacing.Please check the suitability before purchasing.
This item is not DOT approved and may not comply with the laws and regulations in your area.